Your wardrobe, made to measure.

Choose the shape, the dimensions and every detail. The drawing updates as you make your choices. The quote is prepared after we have reviewed the project.

Step 1 of 7 · Measurements and type

Measurements and type

Enter the measurements and shape of your wardrobe

How to complete this step

In a few minutes you will have your wardrobe drawn up and ready to request a quote. There is no need to be exact: we take the final measurements at your home before anything is made.

  1. Choose the shape that most closely matches your space.
  2. Say whether the wardrobe is fitted into an alcove or freestanding.
  3. Enter the width, height and depth in millimetres (300 cm = 3000 mm). You can also type «240 cm» or «2.4 m».
  4. Move on to the next step: you can go back whenever you like without losing anything.
Frequently asked questions
How do I measure?
Measure the width at three points (bottom, middle and top) and the height on the left and on the right, then use the smallest measurement. The depth runs from the back wall to where you want the front of the wardrobe to sit.
What if I don’t have exact measurements?
Enter approximate measurements: they are fine for the design and a first idea of cost. We take the final ones at your home, before manufacture.
Which shape should I choose?
Straight: along a single wall. Under-stairs or Sloping ceiling: the height changes from one side to the other. Corner / L-shaped or U-shaped: takes up two or three walls. Other shape: you describe it and we look at it with you.
Fitted or freestanding?
Fitted: goes between walls; you give the measurements of the alcove and we allow for gaps and trims. Freestanding: the sides are visible; you give the outside measurements of the wardrobe.
What depth do I need?
For hanging clothes on hangers, 600 mm is typical. Under the «Depth» field you will see the minimum for hanging with the doors you have chosen.
How do I enter a sloping ceiling or an under-stairs space?
Enter the height on the left and on the right, as seen from the front; one of the two can be 0. «Swap sides» switches them over.
Measurements and type

These measurements are a starting point. Enter your own or confirm that they match your space.

Where will the wardrobe go?

Measurements

mm

From side to side, along the front. In mm: 300 cm = 3000 mm.

mm

From the floor to the ceiling or to the top of the wardrobe.

mm

From the front to the back wall.To hang clothes with sliding: minimum depth 596 mm.

With a width of 3,000 mm we recommend 3 sections with an interior opening of about 975 mm.The number of sections and doors follows the measurements until you choose otherwise.
97597597430002400
Scale diagram. Measurements in mm. Textures are for guidance; the grain may vary.

3 sections · 3,000 mm

Special features (optional)

Example values: change them to your own measurements.

Would you rather we went through it with you? Tell us about your project.

01

What this configurator is, and what it isn't

Think of this tool as a tidy first draft of your project. It turns what you have in your head into clear details: how many units, what width, what type of doors, how much space for hanging and how much for drawers.

It isn't an automatic price calculator. What you see at the end is a summary of your choices, not a figure. The price comes from a member of our team after reading your configuration, which means they can take into account details a screen can't see.

Beige fitted wardrobes with wooden handles and open shelving next to a designer table in Cullera
02

Step 1: type of wardrobe and measurements

You start by choosing what you want: a fitted wardrobe, a full-wall wardrobe, a walk-in wardrobe or a piece for a corner. Then you note down the width, height and depth of the space in centimetres.

Measure with a tape measure at several points, because walls are rarely perfectly straight. If you're unsure, enter the smallest measurement you find and add a note. The measuring visit that follows takes care of fine-tuning whatever is approximate here.

Have you already measured the space?

Send us a photo and the approximate measurements on WhatsApp and we'll give you some initial guidance.

03

Step 2: doors and interior

  • 01

    Here you decide whether the doors will be sliding, hinged or bifold, and how the interior is laid out: hanging rails, shelves, drawer units, shoe racks or an area for suitcases.

  • 02

    A useful tip is to think about what you actually store. Count how many metres of long clothes you have and how many folded items, and let those numbers take priority over looks. If something isn't clear, mark it as a question and we'll sort it out when we reply.

04

Step 3: finishes and final check

You choose the colour and texture of the doors and the interior. The configurator shows you the whole design so you can check that everything fits: measurements, number of doors, the layout of the spaces.

Before continuing you can go back and change anything you like. Nothing is sent until you decide, so it's also a good way to try out variations and settle on the one that works best in your home in Cullera.

05

How the design is sent

When everything is just as you want it, the configurator prepares a WhatsApp message with the complete configuration. All you have to do is press send. If it's easier for you to attach photos of the space, you can do that in the same conversation.

With that information, our team reviews the design and sends you a guide price within the next 24 hours. It's a free estimate based on your details, which lets you know whether the project fits your budget.

Empty alcove in a bedroom with a tape measure, ready for a made-to-measure fitted wardrobe in Cullera
06

What happens next

If the guide price suits you, we arrange the measuring visit. It costs €50 only if you ultimately don't place an order; if you do, there's no charge. After measuring up at your home, we draw up the final quote.

Manufacturing usually takes between two and three weeks on average. The installation is coordinated separately, so we'll agree a date with you that suits you best.

07

If you'd rather not use the configurator

  • 01

    You don't need to use the tool to get started. You can write to us directly with photos and approximate measurements from the request a quote page or through our contact channels.

  • 02

    The result is the same: a real person reads your case and replies. The configurator simply saves you some questions, because the details we need arrive already organised.

Questions

Frequently asked questions about wardrobes in Cullera

Does the configurator give me a price on screen?

No. It shows your design and your measurements, but the amount is worked out by our team once we receive the configuration. We'll send it to you as a guide price via WhatsApp.

What if I don't have all the measurements?

You can send the configuration with the ones you have and make a note of what's missing. It can be completed in the conversation or during the measuring visit.

Can I change the design after sending it?

Yes. Tell us on WhatsApp what you'd like to change and we'll adjust the proposal before moving on to the measuring visit.

Can it be used for walk-in wardrobes as well as wardrobes?

Yes, you can design both wardrobes and walk-in wardrobes. You enter the space available and the interior layout you need.

Your idea is the first step.

Would you like us to go over your wardrobe with you? Tell us what you need and we'll agree the details during the visit.

If you've already put your design together, use "Send project via WhatsApp" in the configurator to share your selections.

Your satisfaction is our priority We listen to your ideas and go through the measurements, finishes and every detail of the project with you.
WhatsAppQuote